Sembra che le zoe stiano quasi sparendo e rimpicciolendo: qualcuno può aiutarmi?
Zoas seem to be almost disappearing and shrinking, can anyone help me
Commenti
Accedi per lasciare un commento
Ancora nessun commento
Inizia tu la conversazione.
Ho notato che preferiscono un po’ più di nitrati e fosfati. Quelli tuoi dovrebbero andare bene. Come sono gli altri valori? Calcio, magnesio, alcalinità?
I noticed mine prefer slightly higher nitrate and phos. Yours should be OK. How are the other parameters? Calc, mag, alk?
Non controllare altro che nitrati e fosfati, prima o poi vado a fare anche il test dell’Alk.
Don’t check anything other than nitrate and phosphate, going to get an Alk test at somepoint
L’alcalinità non dovrebbe influenzare così drasticamente le zoe. Sono un corallo molle: ho tenuto zoe con Alk a 5.8 prima e andavano bene.
Alk shouldn’t drastically affect zoas like that. They are a soft coral, I’ve kept zoas in a alk of 5.8 before and they were fine
Ho avuto lo stesso problema con alcune Zoas nella mia vasca. Ho notato che alcuni tipi non si fanno problemi a stare sul fondo, e altri invece svaniscono sul fondo. Penso anche che alcuni altri coralli molli si prendano lo spazio e blocchino la loro luce. La cosa che ha funzionato meglio per me è metterle a metà vasca, con acqua ricca di nutrienti.
I had the same issue with certain Zoas in my tank. I’ve noticed that some types don’t mind being at the bottom of the tank, and I’ve had others fade out at the bottom. I also think that some other soft corals over take the space and block their light. I’ve had best luck with them at mid tank, and nutrient rich water.
Le zoe possono essere schizzinose con luce, movimento e nutrienti. IME quasi tutte tendono a preferire un’acqua un po’ più “sporchetta”. Illuminazione e flusso possono essere diversi per ciascuna. Sono anche suscettibili a certi predatori da hitchhiker tipo ragni, lumache, stelle ecc. Ho persino visto anfipodi più grandi che si mangiavano polipi già stressati di notte. Anche alcune malattie: zoa pox e “melting”. Più costose, più è facile che si sciolgano, è sempre stato così. Negli anni ho fatto iodine dip, lugls, perossido ecc. Per lo più niente effetto. La cosa migliore che puoi fare è staccarle: il cemento o la colla di solito si staccano da soli. Spostale in una zona a flusso più basso e tieni via le alghe con una siringa/baster. Può riprendersi, può anche no. Ho 5 talmente piccole proprio ora su una roccia dove la colonia era sparita completamente per probabilmente 5 anni. Le zoe sono strane.
Zoas can be picky with light, flow and nutrients. IME most tend to prefer a little "dirtier" water. Lighting and flow can be different for each one. They're also susceptible to a few hitchhiker predators like spiders, snails,stars etc. I've even seen bigger aphipods munching already stressed polyps at night. Susceptible to a few diseases also, zoa pox and melting. The more expensive the more prone to melting is how they've always been. I've done iodine dips, lugls, peroxide etc over the years. Most of the time to no effect. Best you can do is pry it up, the cement or glue usually pops off. Move it to lower flow and keep any algae off of it with a baster. Might come back , might not. I have 5 very tiny ones right now on a rock that the colony was completely gone from for probably 5 years. Zoas are weird.
Secondo me si stanno sciogliendo o si stanno irritando tantissimo per via degli anfipodi… o magari entrambe.
I feel they either are melting or getting extremely irritated by amphipods and maybe both
Sembra che il flusso possa stare stressandole un po’?!
Looks like flow might be stressing em out a bit?!
Accedi per partecipare alla conversazione.
Potrebbe essere un paio di cose. Anche a me alcune si sono lentamente rimpicciolite col tempo. Alla fine ho scoperto che non gli davo abbastanza par/luce. Ho iniziato con le luci basse come dicevano tutti, ma poi non ho mai lavorato ad aumentare gradualmente il par nel tempo.
Could be a few things. I had a couple of mine slowly shrink over time. Turned out I wasn’t giving them enough par/light intensity. I started lights low like everyone suggested but I never worked on slowly upping the par overtime
Le ho incollate giù adesso quindi non posso più cambiarle, sembravano andare bene da 3+ mesi.
I’ve puttied them down now so can’t change them, they seemed to be fine for 3+ months